cglam in Etobicoke

I found Ash from Redflagdeals where he had great ratings. RFD ID is newlyborn. We were looking to replace our water heater with a tankless (Rinnai) and furnace (Lennox). He came by that night to give a very reasonable quote and left it with us to decide (no pressure) and was very communicative throughout the process. Our water heater then broke down while we looking for costs for someone to move the water main/drain. He was able to get his crew over quickly and get the furnace and hot water tank replaced in one day. The crew (Raj and I can't recall the other person's name) put down runners on the floor and around the work area. They left everything clean when they were done. Unfortunately (things do happen with even the best of products/installations), the furnace cut out after a few hours of running. I let Ash know the next morning and he had Raj back to take a look at the issue a few hours later. The problem was intermittent (would run for 45min to an hour then cut off). They stayed for a few hours to troubleshoot and adjust. Things were working fine when they left but then 45min later it cut out again. I let Ash know and he came by himself that evening to replace the pressure sensor. Everything was handled the same day the issue was reported and Ash took great care to follow up and ensure things were still running over the next few days. He even delayed payment for a week until we were fully satisfied. I would highly recommend him to anyone.

Many people can take down a wall but ensuring that you trust the contractor to keep the house still standing is where it counts. Mario and Nitu were awesome in guiding us through the process and providing their expert opinions. We put our trust in their skills and the reward of not having to worry that things weren't done properly was well worth it. We had an architect draw up the plans to remove a major load bearing wall. The plans called for fully embedded metal I beams that transferred the loads to our exterior walls. It required a long 20+ft metal beam that went the width of the house and then two 12+ft separate connecting metal beams to support the 2nd floor. Doing this job required taking down the old walls and precise measurements to ensure that the beams went into their notched out pockets. They house had a stucco covering so they were very careful and mindful that their notching process in the brick did not cause any damage to the exterior facade. All through the process, they were very careful to ensure we understood the risks and provided options if we felt uncomfortable. Their guys were able to maneuver a 20ft+ metal beam in a smallish Etobicoke house with ease and caused no damage during the process. Being an older house, it is expected that things will come up when the walls were opened. After the metal beams went up, the supporting walls could not be removed immediately. The joists had shrunk from the old bearing wall leaving a gap between the joists and the level beam. Bedna knew we needed to get the job quickly as we had small kids so Nitu went beyond all our expectations to escalate and bring in necessary people to complete the process. All throughout the process, Nitu did a great job in keeping us updated (almost on a daily basis) on the various stages of the project. She was very involved in the process...treating it almost as if it were her own home...and provided the best service that we could have asked for. Nitu, Mario, and the Bedna crew are tops.